Tricity Bendix SG205/1WL Manual de usuario Pagina 14

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 32
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 13
14
Oven Cavity
The enamelled oven cavity is best cleaned
whilst the oven is still warm.
Wipe the oven over with a soft cloth soaked
in warm soapy water after each use. From
time to time it will be necessary to do a more
thorough cleaning, using a proprietary oven
cleaner.
DO NOT clean the oven door while
the glass panels are warm. If this
precaution is not observed the glass
panel may shatter.
If the door glass panel becomes chipped
or has deep scratches, the glass will be
weakened and must be replaced to
prevent the possibility of the panel
shattering.
Contact your local Service Centre who
will be pleased to advise further.
IMPORTANT: The inner door glass must be
in place when using the oven.
Hob
After every use wipe with a soft cloth well
wrung out in warm water to which a little
washing up liquid has been added, avoiding
any leakage through the holes of the hob.
Rinse and dry with a soft cloth.
To remove more stubborn stains, wet and
leave to dissolve, do not scratch and
avoid the use of abrasive or caustic
products that could damage the enamel.
Burners
The burner caps and crowns can be
removed for cleaning.
Wash the burners caps and crowns using
hot soapy water, and remove marks with a
mild paste cleaner. A well-moistened soap
impregnated steel wool pad can be used
with caution, if the marks are particularly
difficult to remove.
After cleaning, be sure to wipe dry with a
soft cloth.
Burner
cap
Burner
ring
IIgnition
SOMETHING NOT WORKING
If the appliance is not working correctly,
please carry out the following checks, before
contacting your local Service Force Service
Centre.
IMPORTANT: If you call out an engineer
to a fault listed below, or to repair a fault
caused by incorrect use or installation, a
charge will be made even if the appliance
is under guarantee.
Symptoms Solutions
1. No burner ignition
Check that:
Gas supply is completely open
The position of gas pipe is correct
The burner is not wet
The burner cap and ring burner have been
replaced correctly after cleaning
Vista de pagina 13
1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 31 32

Comentarios a estos manuales

Sin comentarios