Tricity Bendix SB411W Manual de usuario descargar pdf (Pagina 7)

WARNING: THIS COOKER MUST BE EARTHED

RATING PLATE

Record the model, product and serial numbers on

the back cover of this instruction book from the

rating plate. This is situated on the lower front

frame of the cooker and can be seen upon opening

theovendoor.

The cooker must be protected by a suitably rated

fuse or circuit breaker. The rating of the cooker is

given on the rating plate.

Do not remove the rating plate from the cooker

as this may invalidate the guarantee.

INSTALLATION

If your cooker has been damaged in transit,

contact your supplier immediately. DO NOT

attempt to install it.

Your cooker left the factory fully packaged to

protect it from damage. If it is delivered without

packaging and damage has occurred, the

manufacturer cannot accept responsibility. Contact

you supplier for advice.

Once the packaging has been removed the cooker

should only be moved by hand. DO NOT use a

sack barrow or any other aid to lift the cooker as

damage may occur.

Connection to the electricity supply must be carried

out by a qualified electrician/competent person.

The electrical connection should be made using a

double pole isolating switch (cooker socket) with at

least 3mm contact separation in all poles. The

cable must have conductors of sufficiently high

cross-sectional area to prevent overheating and

deterioration.

Six square millimetres (6.00mm

)

SB 411WTS

The electrical connection must be made using an

all pole isolating switch, or other suitable means of

disconnection, with at least 3mm contact

separation. The cable must have conductors of

sufficiently high cross-sectional area to prevent

overheating and comply with all relevant wiring

regulations

The cable should be routed away from potentially

hot areas marked by an ‘X’ in the diagram below.

To move the cooker, open the main oven door, and

lift the cooker by holding inside the top of the oven

compartment.

This is a type Y appliance, which means it is free-

standing and can be fitted with cabinets on one or

both sides.

Side walls which are above hob level should be

protected by heat resistant non-combustible

material and MUST NOT be nearer than 40mm to

the hob side.

A nominal air gap of 2mm at the sides of the

cooker is required to enable the cooker to be

moved into position.

Overhanging surfaces or a cooker hood should be

a minimum of 685mm above the hob.

It is important to ensure that the appliance is level

after installation. Levelling feet are fitted to the

appliance to accommodate uneven floors.

INTRODUCTION

1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Comentarios a estos manuales

Sin comentarios

Tricity Bendix SB411W Manual de usuario Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Placas Tricity Bendix SB411W